🪵 Woodworking & Casting Precision

Epoxy Resin & River Table Calculator

Calculate exact resin and hardener volumes, 1:1 and 2:1 mix ratios, and mass in grams to prevent exothermic cracking or wasted material.

📐 Dimensions & Shape

inches
inches
inches
Recommended for pours > 0.5" thick (slower cure, zero overheating).

🎯 Resin Requirements

Total Volume Needed
351
Fluid Ounces (fl oz)
≈ 2.74 Gallons (10.38 Liters)
Part A (Resin)
234.0 fl oz
≈ 7,720 grams
Part B (Hardener)
117.0 fl oz
≈ 3,380 grams
Cubic Volume
576 cu in
Exotherm Risk
Safe / Low Heat
Demold Time
48–72 Hours
Ideal Room Temp
70°F–75°F (21°C–24°C)

🛠️ Recommended Deep Pour Resins, Pigments & Woodworking Tools

2:1 Deep Pour Epoxy Resin (3 Gallon Kit)
Slow-cure crystal-clear epoxy for river tables, live edge slabs, and castings up to 2"-4" deep.
Check on Amazon →
Digital Gram Scale (0.1g Precision 5kg)
Heavy-duty digital lab scale for accurate mass-ratio mixing without measuring cup errors.
Check on Amazon →
Silicone Reusable River Table Molds & Form Tape
Tuck tape and non-stick silicone forms to prevent messy mold leaks and wood adhesion.
Check on Amazon →
Dual Temperature Heat Gun / Micro Torch
Instantly pops surface micro-bubbles and air entrapment within the first 45 minutes of pouring.
Check on Amazon →

⚖️ Affiliate Notice: As an Amazon Associate, this site earns from qualifying purchases at no additional cost to you. We strictly link to quality workshop supplies, silicone molds, and casting resins.

Woodworker's Epoxy Resin FAQ

How do you seal live edge wood before an epoxy river pour?
Always apply a thin seal coat of 1:1 tabletop epoxy onto the raw live edges with a foam brush 4 to 6 hours before your main pour. Wood pores contain trapped air; without a seal coat, the warm curing epoxy pulls air out of the timber, creating persistent bubbles along the wood-epoxy boundary line.
What causes epoxy resin to flash cure or overheat?
Epoxy cures through an exothermic (heat-generating) chemical reaction. If a fast-curing 1:1 resin is poured deeper than its recommended limit (usually 1/4" to 1/2"), the heat cannot dissipate, causing the core temperature to spike above 200°F (93°C). This results in yellowing, thermal stress fractures, and smoke. For depths over 1/2", always use a slow-curing 2:1 deep pour casting resin.
How much pigment or mica powder should I add to epoxy?
A general rule of thumb is 1 to 2 grams of mica powder per 16 fluid ounces of mixed epoxy for a vibrant metallic shimmer. For liquid alcohol inks or translucent dye tints, add 2 to 5 drops at a time until reaching desired opacity. Never exceed 5% total additive by volume, or the curing strength will be compromised.