โš“ ABYC Marine Electrical Standards

Boat Dual Battery & Automatic Charging Relay Calculator

Calculate outboard engine cranking amps (CCA), house deep cycle amp-hours (Ah), and ACR charging relay isolation.

๐Ÿ“ Outboard Engine & Marine Electronics

hours

๐ŸŽฏ Recommended Marine Battery Setup

Recommended House Deep-Cycle Battery
115 Ah
Group 27 or 31 Deep-Cycle (12V)
Starting Battery: 650+ Marine Cranking Amps (MCA)
Total Current Draw
11.5 Amps
Engine-off electronics
Total Amp-Hours Used
57.5 Ah
During 5.0 hour drift
Automatic Charging Relay
Blue Sea SI-ACR (120A)
Dual Battery Switch
Off / 1 / 2 / Combine
Starter Battery Isolation
100% Protected from Draining
Marine Cable Size
1/0 or 2/0 Tinned Copper

๐Ÿ› ๏ธ Recommended Tools, Hardware & Building Supplies

Blue Sea Systems 7650 Add-A-Battery Dual Circuit System with 120A ACR
Automates dual-battery management, combining banks during charging and isolating starting battery at rest.
Check on Amazon โ†’
NOCO Genius GENPRO10X2 2-Bank 20A Marine Waterproof Battery Charger
IP68 waterproof onboard smart charger with independent banks for starting and deep cycle AGM/Lithium.
Check on Amazon โ†’
Rule 25DA Submersible 500 GPH Automatic Marine Bilge Pump
Compact computerized bilge pump senses water depth every 2.5 minutes without mechanical float switch.
Check on Amazon โ†’
Fastronix Marine Dual Battery Stud Junction Distribution Block
Stainless steel 3/8-inch power distribution posts for high-amperage outboard trolling cables.
Check on Amazon โ†’

โš–๏ธ Affiliate Notice: As an Amazon Associate, this site earns from qualifying purchases at no additional cost to you. We strictly link to trade-grade construction tools, hardware, and safety materials.

Frequently Asked Questions

What is an Automatic Charging Relay (ACR) on a boat?
An ACR connects your starting battery and house battery together automatically whenever the outboard alternator is charging (over 13.0V). When the engine is turned off and voltage drops, the ACR immediately disconnects the two banks, preventing stereos and chartplotters from ever draining your engine starting battery.
Why can't I use a standard deep-cycle battery to start my outboard engine?
Deep-cycle batteries have thick lead plates designed for slow, continuous power over many hours. Starting an outboard engine requires an instantaneous surge of 500 to 1,000 cold cranking amps. Using a deep cycle battery for starting causes severe voltage sag and can damage sensitive outboard starter motors.
Why is marine tinned copper wire required over standard automotive wire?
Automotive wire uses bare copper strands. In salty humid marine air, moisture wicks beneath the insulation, turning the copper green with verdigris corrosion within months. ABYC compliant marine wire has individually electro-tinned copper strands that resist salt oxidation indefinitely.