๐Ÿ—๏ธ Metal Roofing Alliance Standards

Metal Roofing Panel & Fastener Calculator

Calculate panel counts for 36" corrugated or 16" standing seam metal roofs, ridge caps, trim, and screws.

๐Ÿ“ Roof Dimensions & Panel Profile

ft
ft
inches

๐ŸŽฏ Roofing Order Specifications

Total Panels Required
28
Custom Cut Metal Panels
Cut to Exactly 16 ft 2 inches each
Roofing Screws (EPDM)
1,800 Screws
โ‰ˆ 2 Boxes (1,000 pk)
Ridge Cap Trim
40 Linear ft
4ร— 10.5-ft Trim Pieces
Total Roof Area
1,280 sq ft
Roofing Squares
12.8 Squares
Eave & Rake Drip Edge
144 Linear ft
Foam Closure Strips
28 Strips (3ft each)

๐Ÿ› ๏ธ Recommended Tools, Hardware & Building Supplies

Self-Drilling Metal Roofing Screws #10 with EPDM Washers (1000 Pack)
Mechanical galvanized colored hex head screws with sealing neoprene rubber washers.
Check on Amazon โ†’
Universal Inside & Outside Foam Closure Strips (Pack of 20)
Contoured high-density foam seals valleys, eaves, and ridge caps against wasps, snow, and rain.
Check on Amazon โ†’
Malco Sheet Metal Hand Seamer (3-Inch Forged)
Essential hand bending tool for hemming drip edges, valley eaves, and flashing transition bends.
Check on Amazon โ†’
Double-Sided Butyl Lap Tape for Metal Roofing
Non-drying 100% solid butyl adhesive seal for horizontal metal panel end-laps and trims.
Check on Amazon โ†’

โš–๏ธ Affiliate Notice: As an Amazon Associate, this site earns from qualifying purchases at no additional cost to you. We strictly link to trade-grade construction tools, hardware, and safety materials.

Frequently Asked Questions

What is the difference between Ag-Panel and Standing Seam metal roofs?
Ag-Panel (Tuff-Rib) uses exposed screws driven through the 36-inch wide face of the metal panel into the purlins below. Standing Seam panels (12" to 18" wide) interlock over hidden clips with zero exposed screws, eliminating potential screw-washer leaks.
How many screws are needed per square of metal roofing?
For 36-inch wide corrugated panels, plan for approximately 75 to 80 screws per roofing square (100 sq ft). Screws are driven on both sides of every high rib along the eaves and ridge, and every other rib across interior purlins.
How far should metal roof panels overhang into the gutter?
Metal panels should overhang the fascia board or drip edge by 1.5 to 2.0 inches. Overhanging less than 1.5 inches causes rainwater to wick backwards onto the fascia; overhanging more than 2 inches risks water shooting over the gutter in downpours.