☀️ NEC Article 690 Solar Photovoltaic

Solar Array to MPPT Wire Size Calculator

Calculate solar PV string wire gauge (AWG), open-circuit voltage drop, and power loss percentage.

📐 Solar String & Wire Run Specs

V DC
Amps
ft

🎯 Recommended PV Cable Size

Recommended Copper PV Wire
10 AWG
Standard Solar PV Cable
Voltage Drop: 1.25V (1.74%) — Excellent
Array Total Power
1,080 Watts
Peak solar wattage
Power Loss in Cable
18.7 Watts
Resistive heat loss
Total Circuit Loop
80 ft (Round Trip)
Cable Resistance
0.083 Ω Total
Solar Inline Fuse
20A MC4 Fuse
Insulation Rating
USE-2 / PV Wire 90°C

🛠️ Recommended Tools, Hardware & Building Supplies

BougeRV 10 AWG Solar Extension Cable with MC4 Connectors (50ft Red + 50ft Black)
TUV certified XLPO insulated dual-copper wire with IP67 waterproof connectors.
Check on Amazon →
TEMCo Industrial 8 AWG / 6 AWG Solar PV Wire (100ft)
UL 4703 compliant direct-burial sunlight-resistant stranded copper photovoltaic wire.
Check on Amazon →
IWISS MC4 Solar Crimping Tool Kit with Wire Stripper & Spanners
Ratchet crimper set for assembling 14 to 10 AWG solar male and female pin connectors.
Check on Amazon →
BougeRV Waterproof Inline MC4 Fuse Holders (15A/20A/30A)
IP67 waterproof inline diode/fuse holder protects solar parallel strings from short circuits.
Check on Amazon →

⚖️ Affiliate Notice: As an Amazon Associate, this site earns from qualifying purchases at no additional cost to you. We strictly link to trade-grade construction tools, hardware, and safety materials.

Frequently Asked Questions

Why is keeping voltage drop under 3% critical for solar MPPT systems?
Voltage drop in long wire runs represents pure electrical power converted into wasted heat. For solar systems, keeping voltage drop under 2% to 3% ensures maximum wattage reaches the MPPT charge controller, especially during low-light early morning and cloudy conditions.
Why is wiring solar panels in series better for reducing wire size?
Wiring panels in series doubles voltage while keeping amperage constant ($P = V imes I$). Because electrical resistance losses depend on current squared ($P_{loss} = I^2 imes R$), higher voltage drastically cuts power loss, allowing you to use thinner 10 AWG wire instead of thick, expensive 6 AWG wire.
What is the difference between standard THHN building wire and PV Wire?
Standard THHN conduit wire lacks UV stabilizers and thick cross-linked polyethylene insulation. Specialized UL 4703 Photovoltaic (PV) Wire is rated for 90°C wet conditions, direct sunlight UV exposure, and can be run exposed along metal roof mounting rails without conduit.