☀️ Off-Grid & Mobile Energy Architecture

Solar Battery Bank & Inverter Calculator

Calculate required Amp-Hours (Ah), LiFePO4 vs AGM usable storage, solar array wattage, and inverter size for RVs, camper vans, and off-grid cabins.

⚡ Power Consumption Profile

Wh / day
hours

🔋 Battery Bank & System Sizing

Recommended Battery Bank
176
Amp-Hours (Ah) @ 12V
≈ 2× 12V 100Ah LiFePO4 in Parallel (2.11 kWh)
Solar Panel Array
500 Watts
5× 100W or 2× 250W Panels
Pure Sine Wave Inverter
2000 Watts
4000W Surge Capacity
Total Gross Capacity
2.12 kWh
MPPT Charge Controller
40 Amp MPPT
Cycle Lifespan
3,500–5,000 Cycles (10+ Yrs)
Estimated Battery Weight
≈ 48 lbs (LiFePO4)
💡 Voltage Efficiency Tip: Systems over 2,000W of continuous load should operate at 24V or 48V to halve cable thickness and reduce resistive heating loss through heavy-gauge copper wiring.

⚡ Recommended LiFePO4 Batteries, Solar Panels & MPPT Hardware

LiTime / Renogy 12V 100Ah LiFePO4 Deep Cycle Battery
Grade-A prismatic cells with built-in 100A BMS, low-temp cut-off, and 4,000+ deep cycles.
Check on Amazon →
Victron SmartSolar MPPT Charge Controller (100V / 30A or 50A)
Industry-standard ultra-fast MPPT tracking with built-in Bluetooth monitoring for iOS and Android.
Check on Amazon →
Renogy 200 Watt 12 Volt Monocrystalline Solar Panel
High-efficiency PERC solar cells with corrosion-resistant aluminum frame for roof or ground mount.
Check on Amazon →
2000W Pure Sine Wave Power Inverter (12V to 120V AC)
Clean, low-distortion AC power for sensitive electronics, laptops, Starlink, and kitchen appliances.
Check on Amazon →

⚖️ Affiliate Notice: As an Amazon Associate, this site earns from qualifying purchases at no additional cost to you. We strictly link to certified lithium batteries, MPPT controllers, and solar energy equipment.

Off-Grid Solar Battery FAQ

What is the difference between PWM and MPPT charge controllers?
PWM (Pulse Width Modulation) controllers act as basic electronic switches between the panels and battery, forcing the solar panels down to the battery's voltage and wasting up to 30% of potential solar energy. MPPT (Maximum Power Point Tracking) controllers dynamically convert excess voltage into higher charging amperage, providing up to 98% efficiency, especially in cold weather and cloudy conditions.
Why should I avoid discharging lead-acid AGM batteries below 50%?
Lead-acid batteries generate lead sulfate crystals during discharge. If discharged below 50%, the chemical sulfation becomes irreversible, coating the lead plates, permanently reducing capacity, and degrading the battery from 1,000 potential cycles down to fewer than 200. LiFePO4 batteries suffer no sulfation and can be routinely discharged to 85%–90% without harm.
Why is a Pure Sine Wave inverter necessary over a Modified Sine Wave?
A Pure Sine Wave inverter produces clean, smooth alternating current identical to grid power. Modified sine wave inverters produce a blocky, choppy square waveform that creates electromagnetic buzzing, overheats electric induction motors (refrigerators, blenders), and can permanently damage modern laptop chargers, Starlink terminals, and medical CPAP machines.